Programming With Smartcd.mp; Programming With Smartcd.mp And Pc/Laptop - Simons Voss Technologies SmartCD.MP Quick Manual

SmartCD.MP (SI.SmartCD)

6 Programming with SmartCD.MP

6.1 Programming with SmartCD.MP and PC/Laptop

You should always carry out initial programming with desktop software.
Please note the following points:



SmartCards:
Place a SmartCard or SmartTag on the circle on the programming
device and start programming in LSM.
Cylinders:
Place the front of the packaging (the side where the label is affixed) on
the programming device and start programming in the software. You do
not need to unpack products for programming under normal
circumstances. Should programming be interrupted several times, you
can make it easier by removing the cylinder from the packaging.
EN
The current version of LSM 3.3 or higher must be installed on the PC
or laptop.
You must create a backup before updating the software.
Note: You must hold administrator access rights to install the LSM
software in Windows 7/8/10!
6. Programming with
SmartCD.MP
17 / 72