Connection To Pc, Laptop Or Touchbook; Initial Operation - Simons Voss Technologies SmartCD.MP Quick Manual

4. Connection to PC, Laptop or
Touchbook

4 Connection to PC, Laptop or Touchbook

SmartCD.MP can be directly connected to a free USB port (USB 1.1, USB
2.0 or USB 3.0) on a PC or laptop, or on a netbook or Touch Book in the
case of mobile programming, using the supplied cable. If SmartCD.MP
is connected to a USB hub, the hub must have its own power supply.
SmartCD.MP can be used to programme all SC (.MP) digital
components in the SimonsVoss System 3060 directly on a PC or
laptop.
SmartCards or SmartTags can only be programmed if the SmartCD.MP
is connected directly to a PC or laptop.
In the case of mobile programming, you may also use LSM Mobile in
conjunction with a netbook or Touch Book (operating system Windows
7/8/10). In such a case, the programming device must be connected to
the netbook or Touch Book using the USB cable.

5 Initial operation

After you have connected SmartCD.MP to a PC or laptop using the USB
cable, the new USB hardware is detected by the Windows operating
system. The drivers are installed together with the LSM software
automatically.
16 / 72
SmartCD.MP (SI.SmartCD)
EN