Removing The Blade - Makita LS002G Instruction Manual

Removing the blade

To remove the circular saw blade, perform the following
steps:
1. Lock the carriage in the raised position by pulling
and turning the stopper pin in a locked position.
1
► 1. Stopper pin
2. Use the hex wrench to loosen the hex socket bolt
holding the center cover. Then, raise the blade guard
and center cover.
2
1
► 1. Hex wrench 2. Hex socket bolt 3. Center cover
4. Blade guard
3.
the hex wrench to loosen the hex socket bolt clockwise.
Then remove the hex socket bolt, outer flange and
circular saw blade.
► 1. Hex socket bolt (left-handed) 2. Outer flange
4.
spindle with its recessed side facing the circular saw
blade. If the flange is installed incorrectly the flange will
rub against the machine.
4
► 1. Outer flange 2. Circular saw blade 3. Inner
3
4
19 ENGLISH
Press the shaft lock to lock the spindle and use
1 2
3. Shaft lock
If the inner flange is removed, install it on the
1
2
flange 4. Hex socket bolt (left-handed) 5. Spindle
6. Recessed side
3
3
6
5