GE IM-6D Owner's Manual & Installation Instructions page 21

INSTALL WATER LINE CLAMP
4
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
Attach the metal water line clamp
the kit through the clamp
the back of the cabinet.
be used for the tubing from the water valve up to
the icemaker.
7
CONNECT THE WATER LINE
5
Make sure there is enough plastic water line to
extend from the water valve to well into the water
tube inlet
kit with pliers and slide the clamp over the water
tube inlet.
plastic water line into the inlet as far as it will go
Then slide the clamp downward to capture the
plastic water line in place.
Water tube
inlet
49-60704-2
Installation Instructions
ELECTRIC SHOCK
HAZARD
screw
17
hose clamp
3
ROUTE AND ATTACH THE
6
PLASTIC WATER LINE
Fasten the plastic water line to the back of the
cabinet with adhesive-backed fasteners
spacing the fasteners as shown to take up slack in
the line.
WATER VALVE INSTALLED
7
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
REINSTALL THE COVER
8
Reinstall the compressor compartment access
removed previously to reattach the cover to
the back of the refrigerator case. This must be
reinstalled for your refrigerator to function properly.
Adhesive-backed fasteners
for plastic water line
21