Table of Contents
Advertisement
6. Supply hydraulic oil through filling port (3) while
checking the oil level at level gauge (6).
Refer to "Hydraulic Oil" on page 7-17.
* Capacity of
hydraulic oil tank
137 liters
(36 gallons)
* At level gauge center (Tank capacity: 187 L (50 gal)
7. Install breather valve (2).
IMPORTANT: When changing hydraulic oil, take care
not to permit foreign matter such as dirt, water, and
/or sand to enter into the hydraulic oil tank.
8. Start the engine. Slowly raise or lower the arm and tilt
the bucket forward and backward. Stop the engine.
Check for any oil leakage. Check the oil level using
level gauge (6).
Bleed Air from the Hydraulic System
After changing hydraulic oil or replacing the return
filter, pilot filter and/or suction filter, bleed air from the
hydraulic system following the procedures below.
Bleed Air from the Hydraulic Circuit
1. After supplying oil, start the engine. Do not exceed
1000 RPM (min
). Move the bucket and lift arm
-1
cylinders several times to bleed air mixed in the
hydraulic circuit. Do not operate the cylinders to the
end of cylinder stroke, and do not apply a heavy load
to the cylinders.
2. Rest the bucket on the ground to resume the
hydraulic oil level check position.
3. Stop the engine. Check the oil level. Add oil as
needed.
MAINTENANCE
Total oil capacity in
the hydraulic system
200 liters
(53 gallons)
6
7-46
90Z7-7-41
Advertisement
Table of Contents
Troubleshooting
