Example Installations; Signal Type Identification; Warranty & Repair; Signal Driver Cable Example - Digitrax SH2AB Manual

Example Installations

Sample Layout Mainline Setup

Signal Driver Cable Example

Signal Type Identification

Signal masts are marked as A,B, or C configuration by the placement of a
marker resistor in the middle of the board below the mast pole.
Warranty & Repair
Digitrax gives a one year "No Worries" Warranty against manufacturing defects
and accidental customer damage on all Digitrax command stations, boosters,
throttles, decoders, power supplies and layout control devices.
That's it! A simple, straightforward warranty with no tricky language!
Visit www.digitrax.com for complete warranty details and instructions for
returning items for repair.
Please return warranty items directly to Digitrax - DO NOT return items
to place of purchase.
Digitrax, Inc. reserves the right to make changes in design and specifications, and/or to
make additions or improvements in its products without imposing any obligations upon
itself to install these changes, additions or improvements on products previously manufac-
tured.
Made in the USA
A B
Digitrax, Inc. is not responsible for unintentional
errors or omissions in this document
2443 Transmitter Road
Panama City, FL 32404
www.digitrax.com
Need Support?
helpdesk.digitrax.com
Screw and
Spacer
Example Signal Mast
Installation
C
Signal Mast
SMP1
Mounting
Board
Signal Driver
Cable