Consumer Valve Programming Setup - Water Depot Blaster Soft Owner's Manual

Table of Contents

Advertisement

GENERAL OPERATION
When the system is operating on of
Two displays will be shown: time of
day or days until the next regeneration.
Pressing UP or DOWN will toggle
Between the two choices.
TO SET TIME OF DAY
In the event of a power outage, time
of day needs to be reset. All other
information will be stored in memory
no matter how long the power outage.
Please complete the steps as shown to
The right. To access this mode, press
SET HOUR.
TO SET TIME OF
REGENERATION
For initial set-up or to make adjustments,
Please complete the steps as shown to
the right. Access the mode by pressing
SET HOUR and UP simultaneously for
3 seconds.
The user can initiate manual regeneration. The user has the option to request the manual regeneration at
the delayed regeneration time or to have the regeneration occur immediately. Simultaneously press the
UP + DOWN buttons to start regeneration at the next delayed regeneration time. If regeneration is to
occur today an arrow will point to regeneration. For immediate regeneration, simultaneously press and
hold the UP + DOWN buttons for three seconds.
When in regeneration step through the different regeneration cycles by simultaneously pressing the UP +
DOWN buttons.
User Please Note: Please do not attempt to go further into
valve programming other than time of day or regeneration
unless you have a full and comprehensive understanding of
all program features. Incorrect settings are not a warranty
issue and any service call or resetting of valve will be at the
user's expense and may result in labor service charges.
Consumer Valve Programming Set Up
1. Accessed by pressing SET HOUR.
2. Adjust to the nearest hour using UP or
DOWN. An arrow points to PM during
p.m. hours.
3. Press SET HOUR to complete and return
to normal operation.
1. Accessed by pressing SET HOUR and
UP simultaneously for 3 seconds.
2. Adjust time of regeneration hour using
the UP or DOWN. An arrow points to PM
during p.m. hours. Simultaneously press
SET HOUR and DOWN to return to
normal operation.
7

Advertisement

Table of Contents
loading

Table of Contents