Installation - Baumatic BLE360 Instruction Manual

Replacing the light bulb

Installation

Electrical connection
14
169893en.indd 14 169893en.indd 14
WARNING: PLEASE ENSURE THAT YOUR
APPLIANCE IS DISCONNECTED FROM YOUR MAINS
SUPPLY BEFORE ATTEMPTING TO REPLACE THE
LIGHT BULB.
• Remove the plastic cover and replace the bulb with a new one.
• The bulb that you should use is an E14 max, which is the
same as the bulb originally fi tted by the factory.
• Please dispose of the bulb correctly.
• The light bulb is not covered by Baumatic's guarantee.
• Replace the light cover and after waiting fi ve minutes,
reconnect your plug to your mains supply.
IMPORTANT: Before installation and usage, read all
the instructions and make sure that the voltage (V)
and the frequency (Hz) indicated on the rating plate
are exactly the same as the voltage and frequency in
your home. The rating plate can be found on the front
left edge of the inside of the refrigerator.
The manufacturer declines all responsibility in the event of the
installer failing to observe all the accident prevention regulations
in force, which are necessary for normal use and the regular
operation of the electric system.
YOUR REFRIGERATOR IS INTENDED FOR FITTED AND
PERMANENT INSTALLATION.
We recommend that the appliance is connected by a qualifi ed
electrician, who is a member of the N.I.C.E.I.C. and who will
comply with the I.E.E. and local regulations.
• Your refrigerator comes supplied with a 13 amp plug fi tted. If in
future you need to change the fuse in this plug, then a 13 amp
ASTA approved (BS 1362) fuse must be used.
• The wiring in the mains lead is coloured as follows:
Brown
Blue
Green and yellow
• As the colours of the wires in the appliance's mains lead may
not correspond with the coloured markings identifying the
terminals in your spur box, please proceed as follows:
The brown wire must be connected to the terminal marked "L"
(live), or coloured red.
The blue wire must be connected to the terminal marked "N"
(neutral), or coloured black.
The green and yellow wire must be connected to the terminal
Live
Neutral
Earth
12.10.2006 11:41:44 12.10.2006 11:41:44