Care And Maintenance; Cover Removal; Refitting Cover - Britax Car Seat User Manual

Care and Maintenance

Cover Removal

Use a blunt rod or tweezers to
TIP:
assist with tucking and untucking
the cover from hooks in the shell.
To remove base/backrest cover:
1 Unfasten hooks (2x) at rear of
booster seat (fig. A-1).
2 Release fabric from attachment
points (4x) on sides of backrest at
rear of booster seat (fig. A-2).
Unhook elastic loops from
3
attachment points on upper rear of
backrest (2x) and lower rear of
backrest (2x) (fig. A-3).
To remove headrest cover:
Unhook elastic loops (2x) from
4
attachment points on rear of base
(fig. A-4).
5 Unhook elastic loops (2x) from attachment points on bottom rear
of headrest (fig. A-5).
Release fabric from attachment points (4x) on sides of headrest at
6
rear of booster seat (fig. A-6).
7 Unhook elastic loops (2x) from attachment points on top rear of
headrest (fig. A-7).
Refitting the Cover
To refit headrest cover:
1 Hook elastic loops (2x) to attachment points on top rear of headrest
(fig. A-7).
12
7 7
6 6
6 6
2 2
2 2
4 4
1 1
A
2 Hook elastic loops (2x) to attachment points on bottom rear of
headrest (fig. A-5).
3 Fit sides of headrest cover around headrest.
4 Route each elastic from bottom of headrest cover in front of
backrest, then through the slot to the rear of the booster seat and
hook elastic loop to attachment point on rear of base (2x) (fig. A-4).
Tuck adjacent fabric behind attachment points (4x) on sides of
5
headrest at rear of booster seat (fig. A-6).
To refit base/backrest cover:
6 Fit seat section of cover over base, then thread elastic loops through
slots between the base and backrest.
7 Fasten hooks (2x) to opposite side elastic loops at rear of booster seat (fig.
A-1). When attached properly, the elastic will cross at the rear of the base.
8 Loosely fit cover over side wings, then hook elastic loops to
attachment points on upper rear of backrest (2x) and lower rear of
backrest (2x) (fig. A-3).
9 Tuck adjacent fabric behind attachment points (4x) on sides of
backrest at rear of booster seat (fig. A-2).
Cleaning the Cover
HAND WASH, using cold water and mild soap.
LINE DRY, to prevent cover from shrinking.
Bleach, machine wash, or machine dry.
DO NOT:
Cleaning the Shell
SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY
DO NOT: Use solvents, abrasive cleaners, or disassemble
booster seat in any way, except as instructed.
Care and Maintenance
13