Balanced Body CoreAlign 616-085 Assemble Instructions

How to Assemble the Balanced Body
CoreAlign
PARTS LIST (INCLUDED):
Item
Wall Brackets
10 x 2 1/2" pan head screws
10 x 1" pan head screws
6 x 1" flat head screws
7/64" drill bit
Long dowels
CoreAlign ladder frame
* Included for attachment of bracket to wall if needed. Wall mounting
instructions are not included.
TOOLS NEEDED (NOT INCLUDED):
» Drill and
⁄ " drill bit
1
8
» Phillips screwdriver
Note: Assembled ladder is 91" (231 cm) tall. Contact Balanced
Body if your ceiling is lower than 91".
1. Install first long dowel through both legs of ladder as shown
in Figure A.
Ladder for Wall Mount
®
Part Number
616-085
GEN9395
GEN9034
GEN9073
616-117
607-272
607-308
Fig. A
2. Position and hold dowel with 6 inches
extended on both sides from outside
surface of ladder. Drill dowel with 7/64"
Qty
bit through existing hole as shown
6
in Figure B. Insert #6 screw through
6*
pre-drilled hole in ladder and dowel, and
screw ladder to dowel (Figure C). Repeat
12
installing 2 screws per dowel. Ladder
16
with all "rungs" (dowels) installed should
1
look like Figure D.
4
IMPORTANT NOTE: The brackets that hold
1
the ladder to the wall can be installed for
24" on center studs (Figure E) or 32" on
center studs (Figure F). The remaining
instructions are for 24" on center studs.
Fig. E
Fig. F
®
Fig. B
Fig. C
Fig. D
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | info@pilates.com
400-181 | 06.29.18