Thermador PRO HARMONY PA30GLBH Installation Manual

Backguard Installation
9" Low
Model
Back
30" PA30GLBH
36" PA36GLBH
48" PA48GLBH
When using the Flush Island Trim, THERMADOR
recommends a minimum 12" (305 mm) rear clearance to a
combustible surface. Clearances from non-combustible
materials are not part of the ANSI Z21.1 scope and are not
certified by CSA. Clearances of less than 12" (305 mm)
must be approved by the local codes and/or by the local
authority having jurisdiction.
WARNING:
State of California Proposition 65 Warnings:
This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm.
WARNING:
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
The High Shelf can get very hot! DO NOT place the
following items on top of the High Shelf:
• plastics or containers that can melt
• flammable items
• a total load over 30 pounds (13.6kg)
PRO HARMONY
Backguard Installation
22" High 3" Flush
Shelf Island Trim
Included with
PA30GHSH
range
Included with
PA36GHSH
range
Included with
PA48GHSH
range
CAUTION:
®
High Shelf Parts Included
1 – High Shelf top panel
1 – High Shelf front panel
13 – T-20 Torx Stainless screws
14 or 16 – T-20 Torx drill point screws
Low Back Parts Included
1 – Low Back panel
8 or 9 – T-20 Torx stainless screws
8 or 6 – T-20 Torx drill point screws
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
English 1