Thermador PRO HARMONY PA30GHSH Installation Instructions

B A C K G U A R D I N S TA L L AT I O N I N S T R U C T I O N S — P R O H A R M O N Y ™ D U A L F U E L R A N G E S
Front of Range
The back panel of backguard is positioned
inside these two guide channels on the back of
the range.
To avoid possible burn or fire hazard, a backguard designed
specifically for this range must be installed whenever the
range is used.
WARNING
B A C K G U A R D M O D E L N U M B E R S
6"
Range
Low Back
Width
Included with
30"
Range
N/A
36"
N/A
48"
• The backguard must be attached before sliding the range into the final, installed position.
A Low Back or Pot-and-Pan Shelf must be installed when there is less than 12" clearance
from a combustible back wall and the back of the range above the cooking surface. SEE
RANGE INSTALLATION MANUAL.
• An Island Trim is available for covering the backguard area of the range for island
installations; however, the Island Trim can only be used where there is a minimum of 12"
horizontal clearance between a combustible back wall and the back of the range.
• The backguard is inserted inside the guide channels on the back of the range, as shown
in the illustration. (Remove the griddle or grill assembly for sufficient installation clearance
on models so equipped.) Using a T-20 size Torx driver, fasten the backguard with four (4)
screws to the range side panels.
• Pot-and-Pan Shelf models require pre-assembly of the top panel to the shell using nine
(9) of the enclosed Torx head screws. For sufficient load strength, YOU MUST attach two
(2) Torx head screws through the back corners of the top down into the shell.
• To secure the front of the back guard, install three (3) of the Torx head screws through the
lower front panel of the backguard, into the flange at the back of the range's cooktop.
• The Pot-and-Pan Shelf models provide a shelf above the cooktop to keep foods hot or
store cooking pans.
OBSERVE CAUTIONS BELOW.
The Pot and Pan Shelf can get very hot!
DO NOT place any of the following items on top of the Pot
and Pan Shelf:
• "Plastics" or containers that can melt.
• Flammable items.
• A total load over 30 pounds (13.6 kg).
9"
22" Pot and
Low Back
Pan Shelf
N/A
PA30GHSH
PA36GLBH
PA36GHSH
PA48GLBH
PA48GHSH
CAUTION
Island
Trim
PA30GITH
Included with
Range
Included with
Range