Cleaning The Appliance - Baumatic B602 User And Installation Instructions Manual

CLEANING THE APPLIANCE

Always allow the appliance to cool down to avoid a burn injury.
Do not use caustic or abrasive agents, coarse wire wool or hard
tools as these can damage the surface finish. Normally, wiping
with a soft cloth dampened with hot detergent is sufficient but for
stubborn marks the following is recommended:
VITREOUS ENAMEL PARTS: Use only a cleaner that is
recommended for this type of material: avoid chloride-based
products such as bleach.
DOOR GLASS: Do not use any abrasive medium that could cause
damage. Remember that if the surface of the glass panel becomes
scratched, this could lead to a dangerous failure.
To facilitate cleaning, the door
inner glass can be lifted out
after removing the two fixing
screws. Make sure that when
refitting, the glass is correctly
seated in the door recess and
the correct way round. To
facilitate cleaning inside the
oven, the door can be removed
as follows: With the door in the
fully open position, swivel the catch on the lower hinge arm and
clip them on the hook on each upper hinge arm. Hold the door on
each side, lift to unhook the hinge mechanism and pull outwards to
release from the oven. To refit, hold the door in the fully open
position, slide the hinge arms into the oven recesses until the arms
lock into position. Release the hinge retain retaining clips and close
the door fully to complete the refitting. NOTE: Take care not to
dislodge the hinge lock system when removing the door as the hinge
mechanism has a strong spring system!
Do not immerse the door in water at any time.
Care must be taken when cleaning between the door glasses and inside
the inner door frame as there maybe sharp edges due to the manufactu-
ring process.
12