Table of Contents
Advertisement
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This machine is suitable for gouging on concrete, bricks, stone and asphalt. After appropriate accessories are installed,
it can also be used for squeezing and tamping.
For low temperatures, new power tool or long-time storage, the machine reaches the full impact rate only after a certain
time. This start-up time can be shortened by striking the chisel in the machine against the floor one time.
Point chisel (For gravel)
Total length: 410 mm
Standard size: 30mm (Hexagon)
Flat chisel (For crushing asphalt, grooving and squaring)
Total length: 410 mm
Standard size: 30mm (Hexagon)
1. LUBRICATION MACHINE (See Fig. A)
WARNING! The lubricant oil is already filled into
the tank before use, check the oil tank regularly.
Refill oil if you cannot see any oil through the sight glass.
CHECKING THE OIL LEVEL
The lubricant filler screw (a) on the bottom of the
machine is fitted with a sight glass.
Hold the machine in the upright position so that the
chisel tip points downwards.
Use the sight glass on the lubricant filler screw (a) to
check the oil level.
Refill oil if you cannot see any oil through the sight glass.
FILL LUBRICATING OIL
Open the lubricant filler screw (a) on the bottom of the
machine using the included spanner (6). Make sure not to
damage the gasket.
Top-up with oil. See technical data on page 6.
Close the lubricant filler screw (a) to check the oil level.
If the lubrication oil is in the middle of the sight glass,
you filled enough oil.
Fig. A
8
2
a
1
Advertisement
Table of Contents
