Table of Contents
Advertisement
WORKING HINTS FOR YOUR TOOL
Always use sharp good quality chisels. The performance of the chisel is dependent on the quality of the bits used.
1. Reduce pressure on the bit when it is about to break through.
2. Always operate tool using both the handle and the front handle.
3. Make sure that you wear all necessary personal protective equipment.
4. Do not apply excessive pressure to the tool. Expressive force does not speed up the work.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the power supply first.
2. If your power tool work efficiency is reduced, check the lubricant level.
3. If your power tool work efficiency is reduced, check whether the chisel is blunt.
MAINTENANCE
WARNING! Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor ventilation slots clean. Keep all
working controls free of dust. Occasionally you may see sparks through the ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
11
Advertisement
Table of Contents
