Baumatic BV12.2A Instruction Manual page 27

Changing the direction of the Door –
If you want to reverse the swing of your freezer's door, you can
change it. Holes on the opposite side have already been prepared
in the factory and will be plugged on your appliance.
• Remove the cover of the upper hinge. Unscrew the hinge
• Unscrew the upper rail. Replace it to the opposite side of
• Remove the washer from the lower hinge and unscrew the
• Replace the fastener and the washer in reverse order into
• Take off all door hinges and interchange them (instead of
• Put the door of the appliance on the lower hinge.
• Fix the upper hinge and cover it.
• Replace the slide guides to the opposite side of the door.
• Plug the remaining holes with decorate caps.
• Check the gasket. It shouldn't be creased and it should
• Should the deal not perfectly adhere to the casing of the
and take off the door (NOTE: the door is not fixed to the
lower hinge).
the appliance and fix it.
fastener on the lower hinge by rotating it clockwise.
the opening of the lower hinge on the opposite side of the
appliance.
the corner with a hole, insert the one without the hole and
vice versa).
seal well.
appliance, it could be crushed. You will need to be fluff it
back up by using a hair dryer. Blow hot air over it at a
sensible distance and stretch the seal lightly until it is at
the required height.
25