First Run; Check Tightness; Install Power Adapter (S1- A); Initial Use And Start-Up (S1-A) - Viessmann VITOPURE Manual Book

First run

NOTE

Check tightness

After installation, slowly turn on the valve on the main
water supply line.
Inspect all pipe connections involved in the installation
process for water leakage.
Make sure the circuit system is dry before it is powered.
INSTALL POWER ADAPTOR (S1 - A)
Power adaptor is available inside the box.
Insert the round plug at the output end of the power
adapter into the power input hole on the filter.
EN
Connect the power adapter to a power outletadapter
Initial use and start up (S1 – A)
When the device is used for the first time, please check
all connecting fittings to make sure there is no water
leakage.
Connect to power supply. The device enters the working
state. The device display shows the default number of
days in an automatic rinse cycle.
Make proper adjustment by the actual situation.
Manual rinse (S1 – A)
After the initial use and start-up, please start the manual
rinse function.
When the device is in the "Work" procedure, press the
"START" button to enter the "Rinse" procedure. The rinse
pattern in the display screen flashes in cycles.
Start to rinse at the set time.
If the device is in the "Rinse" state, press the "START"
button to close the electric ball valve and stop rinse.
The "SET" button is invalid in the "Rinse" state.
Regardless of whether the automatic rinse function is
turned on, it can start the manual rinse function at any
time.
NOTE
Initial use S1 - M & S1 - B
When the device is used for the first time, please check all
connecting fittings to make sure there is no water leakage.
Slowly turn on the cleaning knob and see whether the
drainage goes smoothly
Check the pressure value displayed on the pressure gauge
Turn pressure regulating knob and check pressure change.
After installation, please set the pointer on the cleaning date
record dial to the current month. If the current month is
December, please set the pointer at 12 on the dial
36