Appendix A: Bulb Replacement; Overview; Replacing The Bulb - Halma Ocean Optics HL-2000-FHSA Installation And Operation Manual

Overview

To order replacement bulbs for the HL-2000-FHSA, consult the
Before replacing the bulb in the HL-2000-FHSA, disconnect the lamp from your
power source and allow the unit to cool for at least twenty minutes, if necessary.

Replacing the Bulb

►
Procedure
Refer to Figure 5 and perform the steps below to replace the bulb in the HL-2000-FHSA Light
Source:
1. Unplug the power connector from the power socket on the HL-2000-FHSA.
2. Loosen the screws on the rear of the unit with the provided 2.5mm Allen wrench.
3. Remove the rear of the HL-2000-FHSA and remove the electronics board from the unit, taking
particular care not to disconnect the fan wires.
4. Loosen the bulb fixture screw from the bottom of the unit with the provided 1.3mm Allen key.
Do not completely remove the bulb fixture screw. It may be hard to reinsert it.
5. Remove the bulb from the HL-2000-FHSA.
000-10000-070-02-201504
Bulb Replacement
Parts
WARNING
Note
Appendix A
List.
17