Halma Ocean Optics HL-2000-FHSA Installation And Operation Manual page 22

A: Bulb Replacement
6. Disconnect the wires from the connection block.
7. Replace the bulb and reconnect the wires to the connection block.
8. Slide the lamp into the housing and secure with the bulb fixture screw.
9. Slide the electronics board back into the HL-2000-FHSA, taking particular care to ensure that the
wires do not come into contact with the fan blades.
The bulb fixture screw is above the fan, behind the blades. Turn the blades, if necessary,
to reach the screw.
18
HL-2000-FHSA Bulb Replacement Diagram
Note
Connection
Block
Lamp
Housing
Fan Wires
Rear / Electronics Board
000-10000-070-02-201504