Tristar And Asap Series Sample Tubes; Inserting Adapters - Micromeritics FlowPrep 060 Operator's Manual

Degasser
Table of Contents

Advertisement

Sample Preparation

TriStar and ASAP Series Sample Tubes

Adapters are included as a standard accessory with the FlowPrep. Additional adapters may be
ordered if needed (refer to Ordering Information, page 5-1.).
Sample tubes and heating station adapters may be very hot. Wear the proper gloves
and hold the sample tube by the upper part of its stem. Hold the isothermal type of
adapter by its handle. Failure to observe these precautions may result in severe burns.
Do not place your fingers inside the heating stations; the stations may be hot enough
to cause burns.

Inserting Adapters

1. Place the adapter over the sample tube.
Adapter Handle
2. Hold both the adapter handle and sample tube stem when placing the sample tube and
adapter in the heating station.
Alternately, you may insert the sample tube in the heating station, then place the adapter
over the sample tube in the station.
3-10
FlowPrep 060
Nov 2010

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FlowPrep 060 and is the answer not in the manual?

Table of Contents