FlowPrep 060
Controlling the Temperature of Heating Stations
The temperature controller, shown below, enables you to specify the temperature of the heat-
ing stations and displays the current temperature.
The controller always displays the current temperature (PV = Process Value) and the set point
(SV = Set Value).
Press
point is displayed. The keys may be held down to rapidly increase or decrease the setting.
The set point is retained when the degasser is turned off and turned back on.
Nov 2010
Lights when power is being
applied to heating stations
Increases set
point temperature
to increase or
to decrease the value until the desired temperature set
Displays current temperature
Displays set point temperature
Decreases set
point temperature
Operation
3-3
Need help?
Do you have a question about the FlowPrep 060 and is the answer not in the manual?