Front Panel
1: Display Section
Four (4) line, 128x32 VFD Display
•
•
Menu navigation via rotary encoder knob, Select/Escape buttons
2: Inputs Section
Ten buttons select the corresponding input source, or the stored LOGO
image, to be placed on program after the TAKE button is pressed.
There are three button states:
Off: The source is not currently on program
•
•
Blinking: The source has been selected and will be placed on
program after the TAKE button is pressed
•
Yellow: The source is on program.
Rear Panel
1
1-3: Input Connectors
1: Six Analog Inputs via HD-15 VGA connectors
•
Supports RGBHV/RGBS/RGsB computer video,
component video (SD or HDTV), S-video, or Composite video
•
10-bits/color sampling at maximum 170 MHz
•
True pixel mapping (1:1) for signal resolutions up to 1600x1200@60
Hz. Sources with higher pixel rates (1920x1080p@60, 1920x1200@60
and 2048x1080p@60) are also supported.
2: Two Digital or Analog Inputs via DVI-I connectors
8-bit digital input per DDWG 1.0 with HDCP support.
•
•
RGBHV data via analog pins of the DVI-I connector
•
The digital source will be processed if valid DVI signals are detected.
The Analog source can be selected via the front panel menu.
3: Serial Digital Input (HD/SD SDI) via BNC connector
•
SD SDI per SMPTE 259M-C (NTSC/PAL resolution)
•
HD SDI per SMPTE 292M (HDTV)
February 2008 - Rev.C
Any item contained in this datasheet may change without notice.
www.barco.com
3: Effects Section
•
FRZ: Instantly freezes the current image that is on program.
•
BLK: Cuts the program to black
•
KEY: The key source will transition to/from program, after the TAKE
button is pressed
4: TAKE
Transitions the selected source or KEY at the pre-selected rate.
2
3
4: Output Connectors
•
Program output in digital format on the DVI-I connector and in analog
format on the HD-15 connector.
•
Progressive resolutions at RGBHV
•
HDCP Encryption support for DVI signals
5: Ethernet
•
RJ-45 connector for 10/100Base-T Ethernet communications
6: Serial RS-232
•
DB-9 connector for communicating with external serial devices.
7: AC Power
•
Input Power: 100-240 VAC, 47-63 Hz
•
240 watts maximum
•
Auto-Ranging
11101 Trade Center Drive Rancho Cordova, CA 95670
4
5
6
Barco Media and Entertainment
Tel. 916 859 2500 Fax 916 859 2515
7