Use Of Switches; Quick Get Start; Restore Factory Settings Restore - Ebyte TLSR8253F512 Serias User Manual

Patch sig mesh group module

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

E104-BT12LSP User Manual

5.1 Use of switches

When E104-BT12 is networked, you need to group the address of the element under the current device.

When I have three devices: A and B and C, use danglog to network them all. Note that all devices that are not low power

nodes are automatically grouped to C000. It is best to remove C000 when you verify switch function.

Then B device element is then assigned to C002 and C device to C003.

If the two switches DIO1 through device A are connected high, then device B lights up, DIO.If one is low, then device B

lights go out.

Switch DIO2 to low C device lights out, DIO2 to high, C device lights on.

This chapter introduces how E104-BT12SPs form networks quickly and how to control network message transmission

and delivery.

Send the following instruction 02 C006 and you'll receive a return 0343 0600, E104-BT12NSP in the same format as the

E104-BT12LSP instruction.

Baud rate:115200, other8N1, do not return to change lanes.

Table of Contents

E104-bt12lsp