Maintenance - Uberhaus PH-891 Operator's Manual

MAINTENANCE

1. Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your heater.
2. Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
3. Wipe the exterior surfaces of the heater occasionally with a damp cloth (not dripping wet), using a solution of
mild detergent and water. Dry the case thoroughly before operating the heater.
Caution: Do not allow water to run into the interior of the heater as this could create a fire or electric shock
hazard.
4. The fan motor is factory lubricated for life and will require no further lubrication.
5.
Store heater in a clean dry place when not in use.
Cleaning of the Electrostatic Filter:
The heater has an electrostatic filter located in the rear of the heater. The cleaning of the filter should be
performed once per month or as needed (when dust is visible on the filter) to ensure efficient operations of the
heater.
1. Power the heater off by pressing the Power button
2. Unplug the heater's power cord.
3. Release the filter by pushing filter up from below. (Figure 1)
4. Remove the filter by pulling down and out. (Figure 2)
5. Clean filter by vacuuming filter clean.
6. Replace the filter by sliding the top upwards into the spring
loaded slot on the back of the heater (Fig. 2). Then gently push
bottom of filter into place (Fig. 1).
Product Specifications
Model No: PH-891
Voltage: 120 V, 60 Hz
Current: Maximum continuous draw: 12.5 amps
Output: 5200 BTU
Power: 1500 Watts
Turbo Fan: Multi blade; low noise
located on the left side of the Control Panel.
Figure 1
7
Figure 2