Table of Contents
Advertisement
2
Startup and testing the reader DT1
Connect the reader with the USB interface from your notebook or pc
In the device manager there will appear a new device (Silicon Labs CP210x USB to UART
Bridge)
In the brackets you see the port number of the device (e.g. COM5)
Open the "Demo Terminal" on the CD
Open the menu "Settings"
You have to set the following settings: baud rate 19200 baud, 8 data bits, no parity, 1 stop bit,
no flow control.
Send the command „VER <CR>" to the reader. The reader answers with the actual firmware
version (e.g. AEG ID Multi-ISO V2.034).
Send the command „SI <SP> 0 <CR>" if you want to read a ISO 14443A transponder. If you
want to read a ISO 15693 transponder you have to send the command „SI <SP> 1 <CR>".
Send the command "MD <SP> 0 <CR>" to the reader. The reader sends No Read messages
(XXXXXXXX), while there is no transponder in the antenna field available. If there is a tran-
sponder present in the antenna field the reader sends its serial.
3
AEG ID instruction set
3.1
General
The command set described below defines the transfer of data on the serial interface.
The commands consist of a command code and optionally of a parameter value. Commands are ter-
minated by the control character <CR> (0Dh). The control character serves as command line termi-
nator.
Command codes and parameters,including all letters and numerical values, are principally transmit-
ted as a sequence of ASCII characters (the value 255 (decimal) consequently as 32H, 35H, 35H; the
command RST as 52H, 53H, 54H).
All numbers (e.g. sectors, blocks) are in the hexadecimal format (see chapter 9).
--------------------------------------------------------------------------------6/45--------------------------------------------------------------------------------
Advertisement
Table of Contents
