Rdm - Read - AEG ARE DT1 Installation Manual

3.4.6 RDM – read page manual
With the command RDM you can read out a page of the transponder. The reading command is executed
single. You have to do a get tag first. If you are using a mifare standard 1K/4K you have to log in, too.
Input format mifare 1K/4K:
Input format ultralight:
Input format ISO 15693:
Input format ISO 15693 multiple blocks:
Output:
Parameters:
PARAMETER 1
1 or 2 characters
PARAMETER 2
1 or 2 characters
PARAMETER 3
1 or 2 characters
PARAMETER 4
32 characters
8 characters
up to 64 charac-
ters
Note: The ISO 15693 regulates just the maximum length of one block. If there is no information
about the block size available in the ISO 15693 transponder, you can set this value with the command
"BS - block size" (chapter 3.6.2).
--------------------------------------------------------------------------------24/45--------------------------------------------------------------------------------
RD <SP> parameter 1 <SP> parameter 2 <CR>
RD <SP> parameter 2 <CR>
RD <SP> parameter 2 <CR>
RD <SP> parameter 2 <SP> parameter 3 <CR>
parameter 4 <CR>
FUNCTION
sector
FUNCTION
block/start block
FUNCTION
end block
FUNCTION
data (mifare 1K/4K)
data (ultralight)
data (ISO 15693)