Wdm - Write - AEG ARE DT1 Installation Manual

3.4.8 WDM – write page manual
With the command WDM you write one page to the transponder. The writing command is executed
alone. You have to select the transponder first. If you are using a mifare standard 1K/4K you have to log
in, too.
Input format mifare 1K/4K:
Input format ultralight:
Input format ISO 15693:
Output (example):
Parameters:
PARAMETER 1
1 or 2 characters
PARAMETER 2
1 or 2 characters
PARAMETER 3
32 characters
8 characters
up to 32 charac-
ters
Note: The ISO 15693 regulates just the maximum length of one block. With the write instruction you
can write multiple blocks at once. The datalenght has to be at least the block size or a multiple of the
block size. If there is no information about the block size available in the ISO 15693 transponder,
you can set this value with the command "BS - block size" (chapter 3.6.2).
--------------------------------------------------------------------------------26/45--------------------------------------------------------------------------------
WD <SP> parameter 1 <SP> parameter 2 <SP> parameter 3
<CR>
WD <SP> parameter 2 <SP> parameter 3 <CR>
WD <SP> parameter 2 <SP> parameter 3 <CR>
ACK <CR>
FUNCTION
sector
FUNCTION
block
FUNCTION
mifare 1K/4K
ultralight
ISO 15693