Table of Contents
Advertisement
INSTALLATION
This product should only be installed by a qualified person familiar with its
operation and associated hazards, and knowledgeable about the special
requirements for installation in hazardous locations. The National Electrical
Code (NEC), local electrical and safety codes, and when applicable, the
Occupational Safety and Health Act (OSHA) should be observed to reduce
hazards to personnel and property. NEC section 500 (Hazardous Locations) is
particularly important. See pages 6 and 7 for motor and gearmotor dimensions.
• CAUTION–To reduce the risk of ignition of hazardous atmospheres,
disconnect the equipment from the supply circuit before opening. Keep
assembly tightly closed when in operation.
• Leads factory-sealed. Do not disassemble any part of this product as that
will compromise its safety in hazardous atmospheres.
• This product should be installed, inspected, and maintained by a qualified
electrician only, in accordance with all applicable electrical codes.
• ATTENTION–Pour réduire le risque d'inflammation des atmosphères
dangereuses, débranchez l'équipement du circuit d'alimentation avant de
l'ouvrir. Gardez l'assemblage bien fermé lorsqu'il est en fonctionnement.
• Fils scellés en usine. Ne démontez aucune pièce de ce produit car cela
compromettrait sa sécurité dans les atmosphères dangereuses.
• Ce produit doit étre installè, inspecté et entretenu par un électricien
qualifié seulement, conformément avec tous les codes de l'électricité
pertinents.
www.bodine-electric.com
WARNING/AVERTISSEMENT
!
5
Advertisement
Table of Contents
