Table of Contents
Advertisement
Step 4: Operate the 34R6BXPP Motor or Gearmotor
• CAUTION–To reduce the risk of ignition of hazardous atmospheres,
disconnect the equipment from the supply circuit before opening. Keep
assembly tightly closed when in operation.
• Leads factory-sealed. Do not disassemble any part of this product as that
will compromise its safety in hazardous atmospheres.
• This product should be installed, inspected, and maintained by a qualified
electrician only, in accordance with all applicable electrical codes.
• ATTENTION–Pour réduire le risque d'inflammation des atmosphères
dangereuses, débranchez l'équipement du circuit d'alimentation avant de
l'ouvrir. Gardez l'assemblage bien fermé lorsqu'il est en fonctionnement.
• Fils scellés en usine. Ne démontez aucune pièce de ce produit car cela
compromettrait sa sécurité dans les atmosphères dangereuses.
• Ce produit doit étre installè, inspecté et entretenu par un électricien
qualifié seulement, conformément avec tous les codes de l'électricité
pertinents.
• Check that gearmotor is securely mounted.
• Check all rotating members. Be sure keys, pulleys, etc. are securely
fastened and safety guards are in place.
• Check for proper mounting and alignment of products, and verify safe
loading on shafts and gears.
1. Start the Motor or Gearmotor
a. Turn the AC power supply on.
b. Turn the inverter on, if one is being used.
c. The motor should start running at rated speed (if no inverter is used) or the
set speed (if an inverter is used).
2. Adjust Speed
a. If an inverter is being used, adjust the speed control of the inverter and
observe if the motor also changes speed.
3. Stop the Motor or Gearmotor
a. Turn the inverter off, if one is being used.
b. Turn the AC power supply off.
12
WARNING/AVERTISSEMENT
!
CAUTION
!
www.bodine-electric.com
Advertisement
Table of Contents
