Toshiba Carrier MMDMMD-AP0120VHG2UL Installation, Operation And Maintenance Manual page 15

INSTALLATION—ELECTRIC HEAT
Electric Heater Accessory-MMD size 12, 18
and 24
The electric heater must be adjusted to fit unit
sizes 1-ton, 1.5-ton and 2-ton unit models
(MMD-AP0120, MMD-AP0180, MMD-
AP0240). See Figures 6b through 6e.
Switch Plate Adjustment Procedure:
To adjust the switch plate to shorten the heat-
er length, remove the two mounting screws
that attach the switch plate to the heater plate.
Screws install from the bottom.
Next, slide the switch plate toward the heater
plate, line up the two holes, and re-install the
two screws. The final assembly is shorter to
match the shallower depth of the 1/1.5/2.0 ton
size cabinets.
SWITCH
PLATE
Fig. 6b — Heater—Long Format
(mounting screws shown by arrows)
035-000051-001
HEATER
PLATE
Page 15 of 60
DANGER
WARNING: Hazardous voltage. Only qualified
personnel must install the electrical service. Dis-
connect and Lock Out all incoming power sources
before connecting to electrical service.
Fig. 6c
Heater—Long
Format
(Bottom view;
mounting
screws shown
by arrows)
Fig. 6d
Heater—Short
Format
(Bottom view;
mounting
screws shown
by arrows)
Fig. 6e
Heater—Short
Format
(mounting
screws shown
by arrows)
MMD IOM 1.2 11-10-2020