can change the output method to the speakers
of the TV via the TV menu.
• When sound of the TV or other components is
output from the speakers of the system, you
can adjust the volume and turn off the sound of
the system using the TV remote.
• While the TV is in PAP (picture and picture) mode,
the System Audio Control function will not work.
• Depending on the TV, when you adjust the unit's
volume, the volume level appears on the TV screen.
In this case, the volume level that appears on the TV
screen and the unit's front panel display may differ.
Setting the Maximum Volume
Level of the System
When the System Audio Control function is
activated, loud sound may be output depending
on the volume level of the system. You can
prevent this by limiting the maximum level of
the volume. For details, see [Volume Limit]
Receiving the digital audio
signal of the TV
(Audio Return Channel)
The system can receive the digital audio signal
of the TV via an HDMI cable when your TV is
compatible with the Audio Return Channel
function. You can enjoy TV sound via the
system by using just one HDMI cable. For
details, see [Audio Return Channel] (page 63).
Operating the system via the
(Remote Easy Control)
You can control the basic functions of the
system via the TV remote when the system's
video output is displayed on the TV screen. For
details, refer to the operating instructions of the
Changing the language for the
on-screen display of the TV
When you change the language for the on-screen
display of the TV, the system's on-screen
display language is also changed after turning
the system off and on.
D. C. A. C. (Digital Cinema Auto Calibration)
can set the appropriate surround sound
• The system outputs a loud test sound when [Auto
Calibration] starts. You cannot turn the volume
down. Give consideration to children and neighbors.
The home menu appears on the TV screen.
Press C/c to select
Press X/x to select [Audio Settings],
Press X/x to select [Auto Calibration],
The confirmation display for [Auto
Connect the calibration mic to the
A.CAL MIC jack on the rear panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied). The front of
each speaker should face the calibration
mic, and there should be no obstruction
between the speakers and the calibration