Sony BDV-HZ970W Operating Instructions Manual page 57

Note
• In TV or STB mode, if you press any of the buttons
above, the TV or STB operation mode button lights
up. (However, depending on the code setting, some
buttons may not work, and the TV or STB operation
mode button may not light up.)
• If you press other than the buttons above when the
remote is in TV or STB mode, the TV or STB
operation mode button does not light up.
• Depending on the TV or component, you may not be
able to use some of the buttons.
Changing the preset code of
the remote (Preset mode)
1
Press HOME.
The home menu appears on the TV screen.
2
Press C/c to select
3
Press X/x to select [Remote Controller
Setting Guide], then press
4
Press X/x to select [Preset Mode], then
press .
5
Press X/x to select the component type
that you want to operate with the
supplied remote, then press
6
Press X/x to select the device's
manufacturer, then press
7
Press POP UP/MENU while pressing
the operation mode button TV (for a TV)
or STB (for a cable box, digital satellite
receiver, digital video recorder, etc.).
The remote enters Preset mode. The TV or
STB operation mode button (whichever
button you pressed) starts flashing.
8
When the TV or STB operation mode
button starts flashing, enter the code
on the TV screen using the number
buttons, then press ENTER.
If you successfully set the code, the TV or
STB operation mode button will flash twice
slowly. If the setting is unsuccessful, the
TV or STB operation mode button will
flash five times quickly.
Note
• You can quit Preset mode by pressing the TV or STB
operation mode button (whichever button is
flashing).
• If you do not operate the remote for more than 10
You can program a remote code that is not
stored in the supplied remote from a different
component's remote, such as a TV remote.
Buttons other than THEATER,
ONE-TOUCH PLAY, [/1, BD, TV, and STB
are assignable.
1
2
[Setup].
3
.
4
5
6
.
.
7
8
seconds during presetting mode, the remote exits
from presetting mode.
Programming the remote code
from another remote (Learning
mode)
Press HOME.
The home menu appears on the TV screen.
Press C/c to select
Press X/x to select [Remote Controller
Setting Guide], then press
Press X/x to select [Learning Mode],
then press .
Press .
Prepare the other remote with the
button which you want to program to
the supplied remote.
Press TOP MENU while pressing the
operation mode button TV (for a TV) or
STB (for a cable box, digital satellite
receiver, digital video recorder, etc.)
for one second.
The remote enters Learning mode. The BD
operation mode button lights up and the TV
or STB operation mode button (whichever
button you pressed) starts flashing.
Press the button on the supplied
remote to which you want to assign the
new remote code.
The TV or STB operation mode button
lights up.
Note
• If the pressed button has already been assigned
a remote code, the TV or STB operation mode
button flashes five times quickly. In this case,
clear the learned remote code of the button
(page 58), then assign the new desired remote
code.
[Setup].
.
57
US