Table of Contents
Advertisement
1. Features
The pneumatic type label holder unit is an attachment dedicated for sewing on labels. The entire
periphery of the label can be sewn on while pressing down on the inside of the label.
Superimposed stitching or backstitching can be done at the start and end of stitching.
2. Specifications
Name
Applicable model:
Stitching range
Maximum speed
Clamp UP position
Pressing operation
Drive source air
pressure
CAUTION
Trouble such as operation errors could occur if the secondary pressure is set too high.
Use within the range of 0.4MPa (4kg/cm2).
： MP-G10-AH (pneumatic type label holder unit)
： PLK-G1010
： 100(X) mm×80(Y) mm
： 2,300 rpm
： 20 mm
： Use foot switch (2-pedal) normally provided with
： 0.5MPa (5kg/cm
Primary side
： 0.4Mpa (4kg/cm
Secondary side:
the electronic sewing machine and the
expansion foot switch (1-pedal)
2
) or more
2
)
- 1 -
Advertisement
Table of Contents
