Panasonic AU-EVA1 Manual page 19

Wireless Control using the Panasonic AJ-WM50P Wireless Module
It should be noted that the supported case between a SKAARHOJ controller and the Panasonic AU-EVA1
camera is via a wired ethernet connection. This is to ensure a robust integration and to achieve a good
user experience (stable connection, responsiveness etc). The Device Core have been optimised to work
on a wired ethernet connection and this is the supported case.
The AJ-WM50P wires module have been tested briefly in order to determine if wireless control of the
Panasonic AU-EVA1 camera is possible from a SKAARHOJ Controller. It is possible but there are
drawbacks. A couple of comments:
-
In the tested setup idle connection to the camera seemed somewhat stable but connection would still
be lost even no interaction was done on the SKAARHOJ controller (most likely a timeout issue)
-
If SKAARHOJ controller was used to transmit a lot of data such as moving the joystick quickly for iris
control, connection would be lost
-
Changing iris quickly could resort in feedback to the SKAARHOJ controller being delayed
-
Delay in changing parameters on the camera was observed
-
If connection was lost it would quickly reconnect
The configuration used for testing are shown below.
SKAARHOJ DEVICE CORES
19