Advertisement
OPERATION
\\\
Functions
MODE
SET
RESET
SCAN
COUNT (CNT)
TIME
CALORIES (CAL)
TOTAL COUNT (TOTAL)
AUTO ON/OFF & AUTO
START/STOP
Battery
The computer uses x2 "AAA" (Um4 R03) batteries. When the display screen light begins to
fade, remove the batteries, and replace them.
Press this button to change the display or to choose a program.
In the setting mode, press this button to increase the setting
value for TIME, COUNT and CAL.
In setting mode, press this button to reset the value for TIME,
COUNT and CAL.
In monitor mode, hold this button for 3 seconds to reset all
values to zero.
Press MODE until "SCAN" appears. The computer will rotate
through all the 4 functions: Time, Count, Calorie, Total Count.
Each display will be held for 6 seconds.
Shows an instant count with a range from 0 ~ 9999. The count
value can be set in advance, when it approaches the preset
count, the computer will beep for 10 seconds.
Count the total time from exercise start to the end with a range
from 0:00 ~ 99:59 minutes. Exercise time can be set in advance,
when it approaches the preset time, the computer will beep for
10 seconds. The maximum pre-set time is 99 minutes.
Count the total calories burned from exercise start to the end
with a range from 0.0 ~ 9999. The calorie value can be set in
advance, when it approaches the preset calorie value, the
computer will beep for 10 seconds.
The total count will be displayed after installing the batteries.
The range is from 0 ~ 9999.
When the machine is not in operation for 4 minutes, the power
will turn off automatically. Once motion begins, the computer
will turn on automatically.
Advertisement
