Closing Of The Unit; Wiautolink Repositioning - ABB wiAutoLink Instruction Manual

1YSA160045-EN - Rev. 5
C.4.5.

Closing of the Unit

Place the cap, holding the tube with the hand, and tighten it using a 34 mm fork spanner (torque between 8 and 10 Nm) without
damaging the O-Ring.
C.4.6.

wiAutoLink Repositioning

Push the interlocking bolt until blocked (it will rotate freely). Do not strike the bolt, nor use any type of tool to reset.
Turn the tensioning device support.
Place the tensioning device support facing the interlocking bolt.
Figure 31.
Figure 32.
22 / 33