Gear; Gear Spring Pressure Brake; Overload Protection; Lubricant - Selection - HADEF 16/12-EX Installation, Operating And Maintenance Instructions

Table of Contents

Advertisement

13.4

Gear

Regular checks of lubrication are necessary. The teeth must be cleaned and re-lubricated after approx. 3
years. We recommend to use a lubricant of class EP2 or similar products. In case of severe conditions of
use (e.g. dust, regular lifting of the nominal load,etc.), please shorten maintenance intervals.
13.5

Gear spring pressure brake

During the check, brake lining wear is verified. The brake linings must be replaced when the wear limit is
already reached at one position of the lining, - as this can be the case when wear of the linings is irregular.
CAUTION!
The brake linings must be free from fracture. Avoid oil, grease, dirt and humidity on the brake linings as this
increases wear.
13.6

Overload protection

DANGER!
The factory setting of the overload protection/slipping clutch is secured by sealing. In case of any changes
will void the warranty. Should maintenance be necessary, please contact a service company authorized by
the manufacturer.
13.7

Lubricant - Selection

FUCHS
SHELL
Renolit FEP 2
Alvania EP 2
Stabylan 5006
--
--
--
Lubricant for food industry – Selection (as option*)
13.8
SHELL
Gearing
FM Grease HD2
Load chain
--
Load hook;
Pulleys
FM Grease HD2
Gear rim;
Drive pinion
* must be mentioned by order
14

Trouble

DANGER!
Assembly, disassembly and maintenance operations must only be carried out in an atmosphere not
prone to explosion!
Please pay attention to the following in case of problems:
 Troubles with the equipment must only be repaired by qualified personnel.
 Secure the unit against unintended operation start.
 Put up a warning note indicating that the unit is not to be used.
 Secure the working area of moving parts of the unit.
 Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
5.52.190A.01.01.04
ESSO
MOBIL
Unirex EP 2
Mobilux EP 2
--
--
--
--
Chain lubricant OKS 451
MOBIL
Mobilgrease FM 222
Optimol Viscoleb 1500
Lubricant FM 100
Mobilgrease FM 222
TOTAL
CASTROL
MULTIS EP2
--
--
Optimol Viscoleb 1500
--
--
KLÜBER
CASTROL
--
Klüberoil 4UH 1-1500 N
--
--
--
KLÜBER
--
Klüberoil 4UH 1-1500
Wolfracoat 99113
19

Advertisement

Table of Contents
loading

Table of Contents