12.6
Check of the suspension bolt
Suspension bolt
dn
kg
mm
5000-50000
25
13
Service
13.1
Load chain
Wear at the links is mainly due to insufficient maintenance of the chain.
To ensure optimal lubrication of the links, the chain must be lubricated at regular intervals, depending on
usage.
Lubricate the chain with oil that creeps.
Always lubricate the chain when it is not under load so that the oil can wet the links affected by wear. It is
not sufficient to lubricate the chain from the outside, as this will not ensure the formation of a lubricating
film within the links. The adjacent link points must always be lubricated to prevent excessive wear.
If the same lifting operations are carried out constantly, the switching area from a lifting to a lowering
movement must be given special attention.
Thoroughly effected lubrication of the chain will prolong the life of the chain by approx. 20 times,
compared to dry run with unlubricated chain.
Wash dirty chain with petroleum or a similar cleaner, under no circumstances heat the chain.
If there are environmental influences that foster wear, such as sand, a dry lubricant should be used, e.g.
graphite powder.
When lubricating the chain's condition of wear should be checked.
Use
Load chain
CAUTION!
Do not use grease for lubrication of load chain.
Without lubrication, manufacturer's warranty and/or liability will be void.
13.2
Pulleys
Use
Pulleys
13.3
Load hook
Check bearings and pulleys yearly
Clean and lubricate the bearings of hooks and pulleys with grease
Slight bearings are maintenance free
When bearings resp. slight bearings are worn of, change the complete pulley
Use
Load hook
bearing
18
dv min
mm
23,8
Recommendation
oil for example: FUCHS RENOLIN PG 220
or special chain lubricant
Use NO grease!
Recommendation
FUCHS
RENOLIN PG220
Recommendation
FUCHS
RENOLIN PG220
Interval
0,2 l
3 month
Interval
Acc. to demand
12 month
Interval
Acc. to demand
12 month
5.52.190A.01.01.04