Wickes PSC1904.1 Manual page 12

2. VACUUM ADAPTER (SEE FIG. B)
Fasten the vacuum adapter onto the dust extraction
outlet until it latches. Secure in position using the screw
provided. Connect a suitable vacuum hose to the adapter.
NOTE: The vacuum adapter must not be mounted when
no external dust extraction is connected. Otherwise there
is danger of the extraction system becoming clogged.
Clean the vacuum adapter regularly to ensure optimum
dust extraction. The vacuum cleaner must be suitable for
the material to be worked.
NOTE: Use of vacuum extraction does not negate the
need to wear personal protective equipment, especially
respiratory protective equipment.
ADJUSTING
1. ADJUSTING THE CUTTING DEPTH (SEE FIG. C1, C2)
Turn the cutting depth lock knob anti-clockwise to
loosen, and raise the saw body away from the base
plate. Set the required cutting depth by aligning the
triangle symbol (b) (at the rear of the upper fixed
guard) with the cutting depth scale. Turn the cutting
depth lock knob clockwise to lock the cutting depth.
When set correctly, the blade teeth should not
protrude further than 3mm beneath the workpiece.
NOTE: It is best to carry out a trial cut before cutting
your workpiece.
2. ADJUSTING THE BEVEL ANGLE (SEE FIG. D1, D2)
Turn the base plate bevel lock knob anti-clockwise to loosen, and tilt the machine away from the base plate. Set the
required bevel angle by aligning the triangle symbol (c) with the base plate angle scale.
Tighten the base plate bevel lock knob by turning it in clockwise direction.
WARNING: Do not use the depth of cut scale when making bevel cuts due to possible inaccuracy.
Fig. B
12
Fig. C1
1
2
b
Fig. C2