Operating Instructions - Wickes PSC1904.1 Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for lengthways and crossways cutting of wood with straight cutting lines as well as bevel
angles to 45° while resting firmly on the work piece.
ASSEMBLY
1. CHANGING A SAW BLADE (SEE FIG. A1-A3)
WARNING:
•
Before performing any maintenance or
adjustment, remove the plug from the socket.
•
Wear protective gloves when mounting the
saw blade. Danger of injury when touching
the saw blade.
•
Only use saw blades compatible with this
machine, check details in these instructions.
•
Do not use grinding discs as the cutting tool
under any circumstances.
- Removing
1) Press the spindle lock button and keep it depressed.
2) Loosen the blade bolt in anti-clockwise direction
with the hex key. Remove the the blade bolt, the
washer (a) and the outer flange.
3) Tilt back the lower blade guard and hold it firmly with
the lower guard lever. Remove the old saw blade.
- Mounting
1) Clean the saw blade and all the clamping parts to be
assembled.
2) Tilt back the lower blade guard and hold it firmly with
the lower guard lever. Place the new saw blade onto
the inner flange.
3) Re-position the outer flange back on the centre of
the blade. Press and hold the spindle lock again.
Aseemble the washer (a) and the blade bolt onto the
outer flange. Use the hex key to tighten the blade
bolt in clockwise direction firmly.
NOTE:
•
Take care that the mounting positions of the inner
flange and outer flange are correct. (SEE Fig. A3)
•
When mounting: Ensure that the cutting direction
of the teeth (direction of arrow on saw blade) and
the direction-of-rotation arrow on the blade guard
match.
•
Blade teeth are very sharp. for best cutting
results ensure you use a saw blade suited to the
material and cut quality you need.
22
Fig. A1
Fig. A2
24
10
Fig. A3
11
23
2
1
1
2
a
12
11