Advertisement
Available languages
Available languages
Introduction
Congratulations on your purchase of the LEDBAR wash wall lamp.
Installation
1. The lamps can be fixed in any position. Leave a safety distance of at least 1m between the light unit
and other objects or persons. To avoid electrical shock hazard, the unit must be grounded.
2. DMX512 connections:
The light is available to receive the DMX512 signal, connect the signal plug to the panel which marked
with "IN", and connect it to the next light. Then, connect to the "IN" of next light from the "OUT". A DMX
signal terminator is recommended on the last unit of the chain. It will avoid damage to the signal caused
by noise. A DMX terminator is a XLR connector which contains a 120Ω resistor between pin 2 and pin 3
of the XLR connector. It must be connected to the last OUTPUT socket of the last unit.
3. The built-in switch mode power supply is designed to fit a wide range of voltages from AC90V-AC240V
voltage and frequency for your local power supply.
OPERATION
10: ON DMX
9: ON Voice
8: ON Auto-run 1
7: ON Auto-run 2
1-6 Auto-run speed
CH1-
MODEL 0-10
11-51
52-91
52-9
92-131
132-232
232-255
© Copyright LOTRONIC - 2010
GB
512 Receiver
Strobe
Auto-run model
Auto-run R, over the green, green over blue (tone light, on to the highest
when the second group began to rise), and finally Colorful Slow - Fast
red background color changing to green and red background to blue, go
blue and green on red, green and at the end of a star, a white water
6 Auto-run
cycle program
6 in process loop to go
Advertisement
