Delta DFS150-485 User Manual page 31

Table 66. GS1 Emulation enable (0x8025)
Bits Default Value
0 0
Table 67. Command Trigger (0x8500)
Bits Default Value
0 N/A
Table 68. Barcode Status (0x8501)
Bits Default Value
1:0 N/A
Table 69. Barcode Length (0x8502)
Bits Default Value
6:0 N/A
Table 70. Barcode Content (0x8503-0x853E)
Bits Default Value
7:0 N/A
Table 71. Firmware Version (0x8800)
Bits Default Value
15;0 N/A
Table 72. Software Reset (0x900A)
Bits Default Value
0 N/A
DFS150-485 2D Fixed Scanner User Guide
Access
UPC-E0 On/Off
R/W
0:Off, 1:On
Access
You can active the scan engine with serial trigger command,
WO
set the value to 1.
Access
0: The barcode has been taken or no bar code has been
2: The new barcode is decoded successfully.
3: The latest decoded bar code overwrote the previous
RO
If the barcode is taken by master device, status will reset to
Access
In slave Modbus mode, the length of barcode should no more
RO
than 120 characters.
Access
In slave Modbus mode, the length of barcode should no more
RO than 120 characters.
1 word(2bytes) = 2 barcode data (ASCII mode)
Access
RO Firmware Version
Access
After set the parameters, user can reboot DFS by set the
WO
value to one.
Description
Description
Description
decoded.
barcode that has not been taken.
zero.
Description
Description
Description
Description
Appendix
A-13