Honda CRF250R Owner's Manual page 85

Piston/Piston Rings/Piston Pin
Piston Installation
1. Place clean shop towels (1) over the crankcase
opening to keep the piston pin clips from
falling into the crankcase.
2. Apply molybdenum disulfide oil (a mixture of
1/2 engine oil and 1/2 molybdenum disulfide
grease containing more than 3% molybdenum
disulfide additive) to the connecting rod small
end (2) inner surface.
(2)
(1) shop towels
(2) connecting rod small end
82
Servicing Your Honda
3. Install the piston (3) with the " " mark (4)
and/or the large valve recesses (5) facing the
intake side of the engine.
4. Apply molybdenum disulfide oil (a mixture of
1/2 engine oil and 1/2 molybdenum disulfide
grease containing more than 3% molybdenum
disulfide additive) to the piston pin (6) outer
surface.
Apply engine oil to the piston outer surface and
piston pin hole inner surface.
Install the piston pin and new piston pin clips
(7).
NOTICE
(1)
Use new pin clips. Never reuse old clips.
Do not let the clips fall into the crankcase.
Do not align the piston pin clip end gap with the
piston cut-out (8).
(3)
(5)
(7)
(6) (7)
(8)
(3) piston (6) piston pin
(7) piston pin clips (new)
(4) " " mark
(5) large valve recess (8) piston cut-out
(4)
(4)
(3)
(7)