Table of Contents
Advertisement
Cleaning & Maintenance
• C heck whether the Headset volume level is set too low. Adjust the
volume to a suitable level.
• I f the sound is not clear and distorted, change the frequency Channel
selection on the back of the Charge Cradle, and then press the Auto
Tune Button on the Headset Receiver for better reception.
distortion
• The battery inside Headset may need charging. Recharge the battery.
• T he Headset may be too far away from the transmitter inside the
Charge Cradle. Bring them closer together.
• T he audio signal input level from the audio source is too low. Increase
the volume at the audio source.
• I f the sound is not clear and distorted, change the frequency Channel
on the back of the Charge Cradle, and then press the Auto Tune
Button on the Headset for better reception.
Cleaning & Maintenance
Note: dO NOT use alcohol, chemical or spirit based cleaning agents.
Wipe Base and Headset clean with a damp cloth.
In case the receiver cannot be linked with the transmitter. Please
follow the following procedure for Pairing:
1.
D isconnect the power adaptor of the transmitter to the electrical
outlet.
Turn ON the receiver.
2.
3.
P ress and hold the MIC button for about 5 seconds, the green
LED flash fast in the receiver, then plug in the power adaptor of the
transmitter to socket.
4.
The receiver and the transmitter is then paired automatically, and the
green LED on the receiver lights steadily.
*Need some help? Call 02 4574 8888 or go to www.oricom.com.au
16
Advertisement
Table of Contents
