Table of Contents
Advertisement
Operation
Initial Operation
1.
Make sure the TV7400 is plugged
into the mains supply.
2.
P lace the TV Headset in the
Charging Cradle for at least three
hours to allow it to fully charge.
• Make sure the TV Headset is
switched OFF (see figure (1)).
• The LED Indicator glows red
during charging.
• It will glow green after the
battery is fully charged
(see figure (2)).
3.
After three hours have passed
and the charging LED has turned
green, you can proceed to use the device.
Routine Operation
1.
S witch on the Audio Source (TV set or other audio device) that the
Transmitter is connected to. The Power LED Indicator will glow
continuously (see figure (3)).
2.
P ut the Ear Phone plug into the 3.5mm phone jack of TV Receiver.
On the TV Receiver, switch ON the On/Off Switch (see figure (4)). The
green Power LED Indicator will glow continuously.
3.
A djust the Volume to the desired sound level (see figure (5)), then fit
the earbuds in your ears.
NOTE: Make sure the volume on your Audio Source (TV set or other audio
device) is turned up to at least half of its full volume to get good sound
quality in your Earbuds.
*Need some help? Call 02 4574 8888 or go to www.oricom.com.au
Operation
(1)
(2)
11
(3)
(4)
(5)
Advertisement
Table of Contents
