Set Calibration Value; Start Measurement; End Measurement; End Measurement - Deprag ME 5600 Operating Instruction Booklet

13.8.5 Set Calibration Value

Command:
Parameter:
Response to setting:
Response to query:
Example: set calibration value to
300
Table 15: Set calibration value
With this command, you can adjust the calibration for each transducer type. If instead of
the calibration value the byte ffh is given as a parameter, The ME5600 will respond with
the present calibration settings.

13.8.6 Start Measurement

Command:
Parameter:
Response:
example: Start Measurement
Table 16:

Start Measurement

With this command a measurement is started.

13.8.7 End Measurement

Command:
Parameter:
Response:
Example: End Measurement
Table 17:

End measurement

With this command the measurement is ended

13.8.8 Set Language

Command:
Parameter:
Response to setting:
Response to query:
Example: Set to English
Table 18:

Language Setup

With this command the interface/displayed language on the ME 5600 can be adjusted.
When ffH is given as the command Parameter, the present setting remains unchanged
and the ME5600 responds with the language parameter of the present setting.
@ 03H 20H <Parameter>
<number> - new calibration value
ffH – query present value
@ 03H
@ 03H 20H <Parameter>
@ 03H 20H 33H 30H 30H 80H
@ 04H
---
@ 04H
@ 04H
@ 05H
---
@ 05H
@ 05H 80H
@ 06H <Parameter>
01H - German
02H - English
ffH – Request present setting
@ 06H
@ 06 20H <Parameter>
@ 06H 20H 01H 80H
44