Energizer EZ40VTDE40N User Manual page 10

Place the upper handle on the lower handle. The
-
holes must be aligned
Insert the cam locks and screw them with the wing
-
nuts.
d. Unfolding and adjusting handle assembly
To raise handle assembly
Pull up and back on the lower handle (F) until
-
it is aligned with the hole position of the arm
support and the mower housing.
To secure the lower handle (F) in place, lock
-
the lower screw (M).
Open the upper cam locks (H).
-
Pull up and back on the upper handle to raise
-
it into operating position.
To secure the upper handle in place, close the
-
upper cam locks (H).
NOTE: If the upper handle is loose or
separated from the lower handle, tighten the
knobs on the upper handle locks by turning
them clockwise.
To lower the handle assembly
Open the upper cam locks (H).
-
NOTE: If the handle lock is difficult to open, loosen
the knobs on the upper handle locks by turning them
counter clockwise.
Lower the upper handle.
-
Unfix the lower screw (M).
-
Fold the handle to the front of the unit.
-
Avoid pinching or trapping any cables.
-