Connecting Your Monitor - Iiyama ProLite TE8604MIS User Manual

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the Touch USB Cable.
Connect the computer to the monitor with the USB Type-C Cable when viewing images on your
monitor through the USB Type-C Connector or when using the monitor's USB hub function.*
Connect the Power Cable to the monitor first and then to the power source.
Turn on your monitor (Main Power Switch and Power Button) and computer.
*  When charging connected device via USB Type-C Connector, check if the device is equipped
with a USB Type-C Connector that supports charging function via USB PD (=Power Delivery).
 The connected device can be charged via USB Type-C Connector even when the monitor is in
standby mode.
 The USB power delivery is up to 65W. If the connected device required more than 65W for
operation or for boot up (when the battery is drained), use the original power adapter that came
with the device.
 If a separately purchased USB Type-C Cable is used, make sure the cable is certified by USB-IF
and is full-featured with power delivery and video / audio / data transfer functions.
 USB C to A cable is not included with the monitor. If you use a USB C to A cable, please note
that you can only transfer data.
 Compatibility with all connected devices is not guaranteed due to different user environments.
NOTE  Make sure that the building installation has a circuit breaker of 120/240V, 20A
(maximum).
 The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
 Make sure you tighten the finger screws at each end of the Signal Cable.
 The touch function is ready for use about 5 seconds after connecting the USB cable and
can be operated with a pen, finger or any other pointer.
 The Class I pluggable equipment Type A must be connected to protective earth.
 The socket-outlet shall be installed near the equipment and shall be easily accessible.
 Excessive sound pressure from ear-/headphones can cause hearing damage/hearing loss.
18 BEFORE YOU OPERATE THE MONITOR