Table of Contents
Advertisement
REVERSING THE DOOR OPENING DIRECTION
The side in which the door opens can be changed
from the right side (as supplied) to the left side, if the
installation site allows for it. Tools you will need:
1.
8mm socket driver
2.
Phillips head screwdriver
3.
Thin-blade screwdriver
Before you begin, place the fridge on it's back in order to
gain access to the base, you should rest it on soft foam
packaging or similar material to avoid damaging the
cooling pipes at the rear of the fridge.
Reverse the door
1.
Stand the fridge, remove the two screws on the back
of the top cover, then lift the top cover and place it
on a padded surface to prevent scratching.
2.
Remove the four screws as shown in the diagram.
Remove the top hinge and keep for reassembly.
18
REVERSING DOOR
(WFM0900, WIM1200 & WRM1400)
3.
Lift the door and place it on a padded surface to
prevent scratching. Remove both adjustable feet and
remove the bottom hinge bracket by unscrewing the
bolts. Then transfer them to the other side.
Note: 1. You need to move the hinge pin from hole
2
to
before transfer. 2. You need to install the foot
on the side which does not have a hinge.
hinge pin
②
①
②
①
②
①
②
①
②
①
foot
②
①
②
①
2
1
②
①
4.
Set the door into its new place making sure the
pin enters the bushing at the lower frame section.
Replace the lid by fitting the upper hinge into the
upper door's hole, securing it with the two screws.
Replace another two screws to another side.
5.
Replace the top cover. Tighten the two screws on
the back of top cover.
replace note copy to read: "Note: 1. You
need to move the hinge pin from hole 1
to 2 before transfer. 2. You need to install
the foot on the side which does not have
a hinge."
LAMP REPLACEMENT
1.
Switch off the power at the power point and remove
the cord by pulling the plug.
2.
Slide out the drip tray from beneath the ice box.
1
3.
Unscrew the light bulb in an anti-clockwise direction.
4.
Screw the replacement bulb into the socket in a
clockwise direction.
6.
Replace the drip tray.
7.
Wait 5 minutes to ensure pressures in the
refrigeration system are equalised, before turning the
refrigerator on at the power point.
WARNING
Never insert your finger into the light bulb socket.
TIPS AND INFORMATION
Not all 15 watt screw-in lamps will fit the lamp housing.
Appropriate replacement lamps can be purchased from
Electrolux or by calling 13 13 50.
LAMP REPLACEMENT
(WIM1200, WRM1400 & WRM2400)
Models WIM1200, WIM1400 are fitted with LED lights.
These are not user serviceable and should be replaced
by an authorised service centre. Normal service call and
labour charges apply.
(WIM1000)
19
LAMP REPLACEMENT
Advertisement
Table of Contents
