Reversing The Door Opening Direction; Wfm0900, Wim1200, Wrm1400 - Westinghouse WRM2400 User Manual

REVERSING THE DOOR OPENING DIRECTION

The side in which the door opens can be changed
from the right side (as supplied) to the left side, if the
installation site allows for it. Tools you will need:
1. 8mm socket driver
2. Cross- sharped screwdriver
3. Putty knife or thin-blade screwdriver
Before you begin, place the fridge on it's back in order to
gain access to the base, you should rest it on soft foam
packaging or similar material to avoid damaging the
cooling popes at the rear of the fridge.
Reverse the door
1. Stand the fridge, remove the two screws on the back
of the top cover, then lift the top cover and place it
on a padded surface to prevent scratching.
2. Remove the four screws as follow diagram. Lift the
upper hinge core, then put it in a safe place.
16
REVERSING DOOR
(WFM0900, WIM1200 & WRM1400)
3. Lift the door and place it on a padded surface to
prevent scratching. Remove both adjustable feet and
remove the bottom hinge bracket by unscrewing the
bolts. Then transfer them to another side.
Note: 1. You need move hinge axis from hole
.
before transfer. 2. You need install the rubber
2
.
.
supporting on the side which haven't hinge.
②
②
②
4. Set the door into its new place making sure the
pin enters the bushing at the lower frame section.
Replace the lid by fitting the upper hinge core into
the upper door's hole, securing it with the two
screws. Replace another two screws to another side.
5. Put the top cover in the freezer. Tighten the two
screws on the back of top cover.
.
.
.
.
.
to
1
hinge axis
② ①
②
①
② ①
② ①
①
② 2
①
1
①
①